The 12-Volt Bible for Boats is a clear, nonthreatening introduction to the 12-volt electrical systems used on small boats to power everything from reading lights to bilge pumps. This second edition is thoroughly updated with respect to modern batteries, breaker and panel design, alternative energy sources, and troubleshooting equipment, but it retains the fundamental simplicity that is the source of its enduring popularity (more than 100,000 copies sold).

John C. Payne is a professional marine electrical engineer with 23 years merchant marine and off-shore oil experience.

More and more sailors and powerboaters are buying and relying on electronic and electric devices aboard their boats, but few are aware of proper installation procedures or how to safely troubleshoot these devices if they go on the blink.

The second in a series of highly practical, hands on, step-by-step photographic manuals, Replacing Your Boat's Electrical System fills a gap in the market for the DIY boat builder and repairer. It is a subject covered only in piecemeal fashion by the yachting press, which, like general boat repair manuals, can't go into the level of detail Micke Westin does. This is a visual, hand-holding guide, dwelling on the details as it explains each procedure rather than focussing on the theory (which is relegated to an appendix, for those who wish to go further).

Provides instructions for wiring marine electronics and dozens of weekend projects, such as installing cabin and navigation lights, burglar alarms, battery charge indicators, bilge alarms, and more. This is a user-friendly manual for on-board electrical projects, from fixing loose connections to rewiring your boat.

A step-by-step instruction manual on how to build a lightweight 'environmentally-friendly' boat with recyclable resources. The boats simply fold up from ¼” thick cardboard obtaining their strength from the geometry of the component parts. The boats are 8-feet long, weigh about 25-pounds, and can accommodate a 250-pound person without risking structural damage. Each boat is constructed with 21-pieces of cardboard that are used to make 7-component parts. The 7 parts are assembled together with 'environmentally-friendly' contact cement and paper drywall tape. Once assembled the boats are sealed with an 'environmentally-friendly' water-based waterproof coating. No special tools are required and they are very simple to build. All of the materials used to build a boat are typically found at 'do-it-yourself' home improvement stores. The boats can be outfitted with 12-volt electric fishing motors, although they are typically propelled with traditional Kayak style paddles.

With clear illustrations and simple explanations, Don Casey shows you exactly how to install wiring ... make good, safe connections ... match your battery bank and alternator to your needs ... troubleshoot problems quickly ... avoid shore power problems ... and more - all without a lot of technical jargon.