Dual fuel pilot ignited natural gas engines are identified as an efficient and viable alternative to conventional diesel engines. This paper examines cyclic combustion fluctuations in conventional dual fuel and in dual fuel partially premixed low temperature combustion (LTC). Conventional dual fueling with 95% (energy basis) natural gas (NG) substitution reduces NOx emissions by almost 90%t relative to straight diesel operation; however, this is accompanied by 98% increase in HC emissions, 10 percentage points reduction in fuel conversion efficiency (FCE) and 12 percentage points increase in COVimep. Dual fuel LTC is achieved by injection of a small amount of diesel fuel (2-3 percent on an energy basis) to ignite a premixed natural gasair mixture to attain very low NOx emissions (less than 0.2 g/kWh). Cyclic variations in both combustion modes were analyzed by observing the cyclic fluctuations in start of combustion (SOC), peak cylinder pressures (Pmax), combustion phasing (Ca50), and the separation between the diesel injection event and Ca50 (termed "relative combustion phasing"). For conventional dual fueling, as % NG increases, Pmax decreases, SOC and Ca50 are delayed, and cyclic variations increase. For dual fuel LTC, as diesel injection timing is advanced from 20° to 60° BTDC, the relative combustion phasing is identified as an important combustion parameter along with SoC, Pmax, and CaPmax. For both combustion modes, cyclic variations were characterized by alternating slow and fast burn cycles, especially at high %NG and advanced injection timings. Finally, heat release return maps were analyzed to demonstrate thermal management strategies as an effective tool to mitigate cyclic combustion variations, especially in dual fuel LTC.

"High fuel efficiency has become an extremely desirable trait for internal combustion engines. This motivation has driven extensive research on methods to improve fuel efficiency on engines of various sizes. Many of these methods involve changes to the properties of the combustion process. One way to induce these property changes is through varying the phasing of combustion. Combustion phasing can be defined as the time in the engine cycle, specifically the compression and expansion strokes, where combustion occurs. A change in combustion phasing causes a change in combustion duration. The duration of combustion impacts how the energy and work potential of the energy (availability) from the fuel are utilized. Analysis techniques based on the first and second law of thermodynamics have been developed to determine the energy and availability distributions. These distributions are utilized to visualize and quantify any improvements made to engine efficiency as combustion phasing is altered. The test engine utilized is a spark ignition (SI) engine meaning that the combustion phasing variations are completed by varying the ignition timing. In light of the test platform being a two-cylinder, industrial-use engine, this thesis focuses on determining the impact of combustion phasing on energy and availability distributions in an air-cooled, rich running utility engine subject to tight manufacturing cost constraints"--Abstract, leaf iii