Labelling on electrical equipment sold by DIY stores must be used to warn that it is illegal for an unregistered person to carry out most electrical works in the home. In addition, public awareness about the risk of the odourless, invisible and potentially lethal carbon monoxide fumes must be raised to increase safety in the home. When it comes to gas and electrical safety, the Committee concludes that far too many homeowners do not appreciate either the dangers of using sub-standard engineers or their own liability when it comes to faulty gas and electrical work. The Government must co-ordinate a concerted effort by key industry organisations to raise public awareness levels on these crucial issues. To that end the Committee recommends that sockets and other electrical equipment sold by DIY stores for electrical installations should carry a health warning that it is illegal for an unregistered person to carry out most electrical works in the home without checks being completed meeting the requirements of the Building Control service. The Committee will be writing to all the big electrical/DIY stores to highlight this key recommendation. In its current consultation exercise into Building Regulations, the Government has examined further deregulation of Part P, which focuses on electrical installation and repair. The Committee highlights how evidence gathered since the introduction of these rules demonstrated that deaths and injuries due to electrical faults have decreased. De-regulation can only be supported if there was clear evidence that safety standards would not suffer, but such evidence has not been provided by the Government.

Archival snapshot of entire looseleaf Code of Massachusetts Regulations held by the Social Law Library of Massachusetts as of January 2020.

This book provides comprehensive coverage of electrical system installation within areas where flammable gases and liquids are handled and processed. The accurate hazard evaluation of flammability risks associated with chemical and petrochemical locations is critical in determining the point at which the costs of electrical equipment and installation are balanced with explosion safety requirements. The book offers the most current code requirements along with tables and illustrations as analytic tools. Environmental characteristics are covered in Section 1 along with recommended electrical installation and safety recommendations. Section 2 treats a number of application illustrations in detail. Section 3 presents examples for the application of classifying NEC Class 1 locations.