High efficiency axial and centrifugal compressors are important in fields as diverse as aircraft engines, superchargers and turbochargers, process and refrigeration compressors. Compressors must achieve high efficiency in blade rows in diffusing flow fields. Of equal and sometimes greater importance is the range os stable operation of the compressor. Blade row stall characteristics determine the limit os stable operation. Blading can stall uniformly with symmetric flow breakdown or asymmetrically in rotating stall, wich propagates around the periphery of the blade row. Depending on aerodynamic conditions, surge may occur instead of, in concert with, or subsequent to blade row stall. The transient breakdown and recovery of aerodynamic loading not only limits compressor performance but also leads to mechanical failures caused by the vibrational loads imposed on the blades. There is no need to know what initiates these performance limits so that surge and stall margins can be optimized and control strategies can be planned. the first step toward understanding is to be knowledgeable about he physical processes occurring during surge and stall. This will permit the designer to anticipate variable geometry needs such as variable inlet guide vanes, variable statuors, and bleed port strategies. Theoritical treatment is far from being well established, however, there are many approaches discussed in the literature. This book is a unique reference to the subject matter. Physical descriptions of the phenomena are given, test results are presented, and analytical studies are discussed. There has been much written about the experimental investigations and theoretical treatments related to surge and stall. To assist those who would pursue advancements in furthering ou knowledge of surge and stall, it seemed appropriate to have a resource that contains a compendium of information on this subject. That is the purpose of this book. [Source : d'après la 4e de couverture].

Masters Theses in the Pure and Applied Sciences was first conceived, published, and disseminated by the Center for Information and Numerical Data Analysis and Synthesis (CINDAS) * at Purdue University in 1957, starting its coverage of theses with the academic year 1955. Beginning with Volume 13, the printing and dissemination phases of the activity were transferred to University Microfilms/Xerox of Ann Arbor, Michigan, with the thought that such an arrangement would be more beneficial to the academic and general scientific and technical community. After five years of this joint undertaking we had concluded that it was in the interest of all con cerned if the printing and distribution of the volumes were handled by an interna tional publishing house to assure improved service and broader dissemination. Hence, starting with Volume 18, Masters Theses in the Pure and Applied Sciences has been disseminated on a worldwide basis by Plenum Publishing Cor poration of New York, and in the same year the coverage was broadened to include Canadian universities. All back issues can also be ordered from Plenum. We have reported in Volume 34 (thesis year 1989) a total of 13,377 theses titles from 26 Canadian and 184 United States universities. We are sure that this broader base for these titles reported will greatly enhance the value of this important annual reference work. While Volume 34 reports theses submitted in 1989, on occasion, certain univer sities do report theses submitted in previous years but not reported at the time.