The book covers basic approaches to the nuclear fuel state of energy reactors in the last stages of the nuclear fuel cycle, these have been developed by the authors based on Ukrainian Nuclear Power Plant (NPP) operational experience. The book starts by looking at the physical safety basis of water-water energetic reactor (WWER) nuclear fuel. It goes on to discuss modern approaches to the heat exchange modelling in nuclear power plant equipment. Next, the safety criteria when making a decision about dry storage for WWER-1000 fuel assembly are discussed. Then the effect of reactor capacity cyclic changes on energy accumulation of creep formations in fuel cladding is covered in full, along with a chapter on the analysis of WWER-1000 fuel cladding failure. Finally, the book finishes with a description of thermal safety criteria for dry storage of spent nuclear fuel. The book is essential reading for anyone concerned with NPP maintenance and safety.

The book covers basic approaches to the nuclear fuel state of energy reactors in the last stages of the nuclear fuel cycle, these have been developed by the authors based on Ukrainian Nuclear Power Plant (NPP) operational experience. The book starts by looking at the physical safety basis of water-water energetic reactor (WWER) nuclear fuel. It goes on to discuss modern approaches to the heat exchange modelling in nuclear power plant equipment. Next, the safety criteria when making a decision about dry storage for WWER-1000 fuel assembly are discussed. Then the effect of reactor capacity cyclic changes on energy accumulation of creep formations in fuel cladding is covered in full, along with a chapter on the analysis of WWER-1000 fuel cladding failure. Finally, the book finishes with a description of thermal safety criteria for dry storage of spent nuclear fuel. The book is essential reading for anyone concerned with NPP maintenance and safety.

On the basis of the principles included in the Fundamental Safety Principles, IAEA Safety Standards Series No. SF-1, this Safety Requirements publication establishes requirements applicable to the design of nuclear power plants. It covers the design phase and provides input for the safe operation of the power plant. It elaborates on the safety objective, safety principles and concepts that provide the basis for deriving the safety requirements that must be met for the design of a nuclear power plant. Contents: 1. Introduction; 2. Applying the safety principles and concepts; 3. Management of safety in design; 4. Principal technical requirements; 5. General plant design; 6. Design of specific plant systems.

This publication is a revision by amendment of IAEA Safety Standards Series No. SSG-15 and provides recommendations and guidance on the storage of spent nuclear fuel. It covers all types of storage facility and all types of spent fuel from nuclear power plants and research reactors. It takes into consideration the longer storage periods beyond the original design lifetime of the storage facility that have become necessary owing to delays in the development of disposal facilities and the reduction in reprocessing activities. It also considers developments associated with nuclear fuel, such as higher enrichment, mixed oxide fuels and higher burnup. Guidance is provided on all stages in the lifetime of a spent fuel storage facility, from planning through siting and design to operation and decommissioning. The revision was undertaken by amending, adding and/or deleting specific paragraphs addressing recommendations and findings from studying the accident at the Fukushima Daiichi nuclear power plant in Japan.

This TECDOC deals with a basic concept of safety margins and their role in assuring safety of nuclear Installations. The document describes capabilities of thermal hydraulic computer codes used to determine safety margins, evaluation of uncertainties, methods for safety margin evaluation and utilization of safety margins in operation and modifications of nuclear power plants.

The present report is a revision of Safety Series No. 75-INSAG-3 (1988), updating the statements made on the objectives and principles of safe design and operation for electricity generating nuclear power plants. It includes the improvements made in the safety of operating nuclear power plants and identifies the principles underlying the best current safety policies to be applied in future plants. It presents INSAG's understanding of the principles underlying the best current safety policies and practices of the nuclear power industry.