Temperature recovery factors were determined on the cylindrical surface of a number of 40 deg cone cylinder models at zero angle of attack and at M = 2.86. The investigation was performed in a 40- by 40-cm intermittent tunnel and an 18- by 18-cm continous tunnel. With atmospheric tunnel-supply conditions, the turbulent recovery factor was found to be 0.89 + or - 0.5% and independent of Reynolds number in the range of 200,000 to 800,000, with Reynolds number based on wall conditions. The turbulent recovery factor can be represented by the cube root of the Prandtl number for a Prandtl number calculated at wall conditions. In the transitional region of the boundary layer, a maximum recovery factor 0.5 to 1% higher than the turbulent value was obtained. Boundary layer history had a marked effect on the value of the recovery factor. The results were compared with the theoretical and experimental findings of other investigators.

Includes title page, table of contents, list of contributors, preface and all indexes of each book.

Equilibrium convective heat transfer in several real gases was investigated. The gases considered were air, nitrogen, hydrogen, carbon dioxide, and argon. Solutions to the similar form of the boundary-layer equations were obtained for flight velocities to 30,000 ft/sec for a range of parameters sufficient to define the effects of pressure level, pressure gradient, boundary-layer-edge velocity, and wall temperature. Results are presented for stagnation-point heating and for the heating-rate distribution. For the range of parameters investigated the wall heat transfer depended on the transport properties near the wall and precise evaluation of properties in the high-energy portions of the boundary layer was not needed. A correlation of the solutions to the boundary-layer equations was obtained which depended only on the low temperature properties of the gases. This result can be used to evaluate the heat transfer in gases other than those considered. The largest stagnation-point heat transfer at a constant flight velocity was obtained for argon followed successively by carbon dioxide, air, nitrogen, and hydrogen. The blunt-body heating-rate distribution was found to depend mainly on the inviscid flow field. For each gas, correlation equations of boundary-layer thermodynamic and transport properties as a function of enthalpy are given for a wide range of pressures to a maximum enthalpy of 18,000 Btu/lb.

From measurements in the free boundary layer of a plate the laws governing the velocity distribution and a new resistance law are derived which, by increasing Reynolds number Re(sub x) afford lower resistance values than the logarithmic law. The transverse velocities, the shearing stress, and the mixing path profiles were also defined.

This book is a self-contained text for those students and readers interested in learning hypersonic flow and high-temperature gas dynamics. It assumes no prior familiarity with either subject on the part of the reader. If you have never studied hypersonic and/or high-temperature gas dynamics before, and if you have never worked extensively in the area, then this book is for you. On the other hand, if you have worked and/or are working in these areas, and you want a cohesive presentation of the fundamentals, a development of important theory and techniques, a discussion of the salient results with emphasis on the physical aspects, and a presentation of modern thinking in these areas, then this book is also for you. In other words, this book is designed for two roles: 1) as an effective classroom text that can be used with ease by the instructor, and understood with ease by the student; and 2) as a viable, professional working tool for engineers, scientists, and managers who have any contact in their jobs with hypersonic and/or high-temperature flow.