This document specifies the type, size, technical conditions of B-type clips for automobiles. This document is applicable to B-type clips, which have a diameter of 6 mm in the mounting hole of the body sheet, AND a connection thickness b = 2 mm ~ 10 mm.

This document specifies the type and size, technical requirements, test methods of type-A rubber plug and type-B rubber plug. This document is applicable to the type-A rubber plugs for automobiles, which have a diameter D0 of thin-walled circular holes ranging from 12 mm to 60 mm. This document is applicable to the type-B rubber plugs for automobiles, which have thin-walled rectangular holes size of 8 mm x l4 mm ~ 25 mm x 31 mm.

This document specifies the type, size, and technical conditions of A-type clips for automobiles. This document is applicable to A-type clips, which have a diameter of D0 = 5 mm and D0 = 6 mm in the mounting hole of the body sheet, AND a maximum connection thickness S of 5 mm.

This document specifies the type, size, technical conditions of double end studs bm = 1.25d. This document is applicable to double end studs for automobiles, whose thread at the screw-in base end is ordinary coarse thread, transition fit thread, ordinary fine thread (thread specification is greater than M16), AND the thread at the screw-in nut end is ordinary coarse thread and ordinary fine thread.

This document specifies the terms and definitions, statistical scope, calculation methods of comprehensive water consumption for unit output of automobile products. This document is applicable to the calculation of comprehensive water consumption for unit output of automobile products.

This document specifies the terms and definitions, basic requirements, infrastructure, management system, energy and resource input, products, environmental emissions, performance, evaluation methods, etc. of the guidelines on evaluation of whole vehicle manufacturing green factory in automobile industry. This document is applicable to the evaluation of whole vehicle manufacturing green factory in automobile industry.

This document specifies the main types and dimensions for tapped and male fitting in the matrix of pneumatic braking system of motor vehicle and towed vehicle. This document applies to the pneumatic braking system of motor vehicles and towed vehicles with air pressure below 2 MPa.