Springs Pond Dam consists of a 77 foot stone masonry spillway and a 73 foot earth embankment with vertical downstream stone masonry wall. At top of dam elevation, the dam impounds 63 acre-feet. The outlet works consist of a 30x42-in stone conduit controlled by a wood slide gate. Under normal conditions, the entire flow, of Middle River discharges over the spillway. This dam has a maximum height of 14.4 feet with the top of dam 4.4 feet above the spillway crest and is classified as small in size with a hazard classification of significant. There are no available records to indicate when construction of the dam took place or the original purpose of the dam. The visual inspection indicates that the water was used for either power or process water at some time but is no longer used. Based upon the visual inspection, the dam is in fair condition with some seepage from the downstream face and some deterioration of the south abutment and approach channel for the outlet works. Some trees and brush are growing on the upstream side of the embankment. There are two outlet structures, neither of which is operable. An outlet at the north end of the dam was originally for control of water for downstream use. There no longer is any apparent need for this outlet. The southerly outlet structure is for use in drawing down the pool. The test flood results in the dam being overtopped by 3.1 feet to an elevation of 487.5 NGVD. At top of dam elevation, the spillway capacity is 2,300 cfs, which is 34 percent of the test flood flow.

The dam at Riverside Pond is a stone-faced earth embankment dam and is used to supply process water to the adjacent factory located just downstream of the dam. the dam has a height of 21 feet and is approximately 180 feet in length (including the spillway). A single span two lane bridge spans the spillway crest. The spillway is a stone masonry/concrete cap, uncontrolled broad crested weir, 64 feet in length. There are two outlet works, one located to the right of the spillway and the other at the left of the spillway. the right outlet works is a gated underground sluiceway that supplies process water to the adjacent mill. Flows at this outlet pass through the mill and discharge through the side wall of the building foundation and return to Furnace Brook. The left outlet works is also gated and is a 42 inch diameter riveted steel plate pipe through the left dam embankment. Based on the visual inspection at the site, the dam is considered to be in POOR condition. Deficiencies observed include: cracks and voids in the upstream masonry face vegetation growing in the upstream and downstream masonry walls, cracks and bulging of the downstream face of the dam, leakage through the left intake gates and deterioration of the outlet pipe, and seepage along the downstream face. Assuming the pool elevation at the top of the dam, the spillway can pass a flow of 4,435 CFS, which represents only 69 percent of the test flood outflow.

The dam, completed in 1961, is an earth embankment approximately 390 feet in length with an emergency spillway at its left with end. It is a flood control project approximately 28.5 feet in height and capable of impounding approximately 520 acre-feet of water. The principal spillway is a drop inlet type structure consisting of a reinforced concrete riser with a 24 inch diameter reinforced concrete outlet pipe through the dam. The grass-bottomed emergency spillway channel is cut into natural ground at the left end of the dam and has a crest length of 125 feet. The top and slopes of the dam are grass covered, with a filter drain at the toe of the downstream slope. Based upon the visual inspection and past performance, the dam is judged to be in good condition. No evidence of instability was observed in the project. There are some remedial measures, such as filling of large holes in the 'waste areas' adjacent to the dam, reestablishment of greasy vegetation in the vehicle tracks on the top of the dam, and institution of a biennial inspection program, which require attention. The spillway capacity with the pond level to the top of the dam is 4700 cfs, which is equivalent to 1300% of the routed test flood outflow.

The dam built around 1852, has a total length of approximately 293 feet, consisting of a 113 foot long, broad-crested masonry spillway between two 90 foot long embankments with masonry downstream faces. The top of the embankments, at elevation 519.0, are approximately 14 feet wide and 3 feet above the spillway crest. The dam is 22 feet in height above the streambed of Furnace Brook and, with the pond level to the top of the dam, impounds approximately 105 acre-feet of water. At the right end of the dam is a canal leading to the Warren Corporation mill downstream. The inlet to the canal is a 6 foot wide by 5.5 foot deep masonry arch culvert. Based upon the visual inspection at the site and past performance, the project is, judged to be in fair condition. No evidence of instability of the project was observed. However, there are items which require maintenance and/or evaluation, such as deteriorated masonry at several locations on the dam and the absence of a low-level outlet for the dam. The spillway capacity, with the reservoir level to the top of the dam, is 1,900 cfs, which is equivalent to 16% of the routed test flood outflow.

The Packers Pond Dam, built about 1880 to provide water for industrial use, is an earth embankment impounding 450 acre-feet of water on Mill Brook. The length of the dam, including the spillway, is 325 feet. The top of the dam averages between 12-15 feet in width and is approximately 18 feet above the old streambed at the spillway discharge channel. The spillway, located at the right end of the dam, is a 64 foot long, broad-crested, stone masonry structure which provides 4.4 feet of freeboard from the crest to the top of the dam. The outlet is a concrete intake and gate structure located on the upstream slope at the left end of the dam. The gate is not functional and the size of the outlet could not be exactly determined. However, the outlet is assumed to be approximately 3 feet wide by 2.5 high. A railroad embankment runs along the downstream toe of the dam. This embankment is about 24 feet in height, with the top of the embankment approximately 12 feet higher than the top of the dam. The spillway capacity with the pond level at the top of the dam is 1700 cfs, which is 28% of the routed test flood outflow.